Their unfinished boxes

The crossover...

The Current crossover is a cheap 2.0 coil with a 3.3 shunt on the woofer. The tweeter has it's original filter a 4.7 cap and an unknown coil.

This puts my investment at:
Woofers: $26.00
Tweeters: $15.00
Crossover: $6.00
Ports: $2.00
Lumber-Scrap
Shipping- ??

Not bad for 49 bucks...

Mounting the tweeter

This is the back side of the baffle showing how I mounted the tweeter. By useing a 5/8 in thick baffle I got it almost perfectly flush.

*Peerless 830392 5.25" Woofer*

*Peerless 830392 5.25" Woofer*

*Peerless 830392 5.25" Woofer*


*Only: * *$ 13.00 *

**
*Weight:* 2.2 lbs.
PDFDownload Spec Sheet
(36 kb)

**
Peerless 5.25" Poly cone woofer
8 ohm
Stamped steel frame with rubber surround
Very smooth response to 5kHz.
F3 of 60Hz in 0.25 cubic foot vented, 1.5" diameter vent by 4" long

Flange diameter 5.75"
Cut out diameter 4.5"
Depth 2.25"

Re 6.1 ohm
Le 1.0 mH
Fs 61.4 Hz
Qms 2.82
Qes 0.45
Qts 0.39
Mms 10.1 g
Cms 0.67 mm/N
Sd 91 cm2
Vas 7.6 liters
BL 7.3 N/A
26mm VC diameter
88.4dB sensitivity 2.83V@1m

PYRAMID TW22M NEODYMIUM TWEETER PAIR

1" silk dome tweeter with a high power neodymium magnet. 1" high temperature, ferro fluid cooled voice coil. Surface mount with adjustable firing angle. Impedance: 4 ohms. Frequency response: 2,000-20,000 Hz. Power handling capability: 60 watts RMS, 95 watts maximum with included 6 dB per octave crossover capacitor. SPL: 90 dB 1W/1m. Net weight: 1/2 lb. per pair.

http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=265-263#

Their home page at Pyrmaid
Not much help is it.